8/7/2023 0 Comments Diy skate ramp easy![]() ![]() ![]() Partially, pin one of your 8 feet 2×4 boards on the width side of the 3/8″-inch plywood using a screw. Place your 3/8-inch board on the ground and length-to-length with your 3/4-inch plywood. You need not make measurements for the coping and steel piece since they’re in an appropriate size already. This line should divide the board into two equal right-angled trapezoids with upper and lower horizontal bases of 22-inch and 74-inch, respectively. Next, draw a diagonal line at the 36.5-inch partition of the board. Divide this portion into two 4-feet planks of wood with your pencil. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |